Windows 10: controller calibration

Hii was trying to calibrate my controller but in settings when i go to controller settings i saw this and it's different than any thing i have seen on youtubeplease help me tnx

:)

 

Controller Calibration Wizard is BROKEN

Hello--

I need some help. I don't get along with computers and am just a step or two above tech-illiterate so please allow for my idiocy. Apologies in advance if I come off as a bit peeved; I've been mucking about with my controller and computer for almost three hours now.

My hard/software: Windows 10, Project64 emulator, retrobit 64 tribute controller (single joystick, essentially the old N64 controller).

Not the problem: My controller is showing up under devices like it should. It interacts with the emulator just fine, except for calibration being absolutely necessary. I can access and run the calibration wizard.

The Problem: When I run the calibration wizard, it never goes through the steps where I calibrate the X and Y axes. It jumps straight to the Z axis, which I don't have and it does not register whatsoever. I just need to calibrate my single joystick, but the calibration wizard on my computer does not provide the proper steps to do so.

With my luck I won't be surprised if this is a never-before-encountered, one-in-a-million chance, unfixable problem. But please, please tell me that it's a simple fix and that I am just an idiot. Thanks in advance, folks.

Here's Hoping,
Belle

 

I need to disable windows calibration in Windows 10

Hello,

• 
  When you say “disable windows calibration” are you referring to Color calibration in windows 10?
  

I would suggest you to try the steps under the section “Calibrate your display” to know more about color calibration in
Windows 10. Check if it helps

"Get the best display on your monitor"

Make Windows easier to see - Microsoft Support

Reply us back with the status of this issue. We will be glad to assist you.

 

Game controller setting and calibration utility

Since moving from Window 7 to Windows 10 I can no longer test or calibrate my Saitek X-56 HOTAS. The controllers are listed in the utility but the testing screen comes up blank. Anyone got any ideas?