Windows 10: Critical process damage

Whenever I boot my pc it always says critical process died and I can’t do anything about it, it keeps bringing it into automatic repair mode but I can’t even access safe mode and no command prompts work, i also can’t do a system restore either. Nothing works

:)

 

critical process died in windows 10

Hi,

To resolve your concern about the critical process died in Windows 10, we suggest that you do the system diagnostics. Here are the steps:

• Boot your computer and continuously press ESC key on your keyboard until you reach the
  Startup menu.
  
• From the Startup menu, press F2 (or whatever the designated key is) for
  System Diagnostics.
• Use arrow keys to navigate and choose Hard Drive Check.
• Choose Extensive Check.

Allow it to finish then boot your computer as normal.

Let us know how it goes.

 

BSOD Critical Process Died  


This is my config, what should i do? - - - Updated - - - I tried also this: Step 1. From the initial Windows screen, accept the default settings for the language to install, the time and currency format as well as the keyboard or input method. Next, click the Repair your computer link instead of Install now. choose Repair your computer Step 2. Select Troubleshoot and then Advanced Options. Step 3. Select Command Prompt. Step 4. Type diskpart and press Enter key. Step 5. Type list disk and press Enter. Now pay attention to the disk number and identify which one is the boot disk. Usually, it is Disk 0; if not, find the disk number in your own case and remember to type the correct one in the following relevant steps. Step 6. Type select disk 0 and press Enter. Step 7. Type list volume and press Enter. Now pay attention to the volume number of the EFI partition. Step 8. Type select volume N and press Enter. Also, type the one in your own case instead of N. Step 9. Type assign letter=N: and press Enter. N: can be replaced by any drive letter that is not taken by any partition. Remember which drive letter you assign here for it is rather useful in the rest steps. Step 10. Type exit and press Enter to leave diskpart. Step 11. Now type N: (the drive lettered you just assigned) and hit Enter. Step 12. Type format N: /FS:FAT32 and hit Enter. Step 13. Type bcdboot C:\windows /s N: /f UEFI and hit Enter. Now repeat the process of running the bootrec /fixboot command, bootrec access is denied Windows 10 should be solved now. But if fixboot access is denied occurs on an MBR disk, continue with Fix #2. All steps until 13. was executed successfully, but still became on bcdboot /fixboot Error: Access is denied. And I have a GPT and no MBR Partition bootrec /rebuildbcd was successfully, founded Win installation: 0 (ZERO) complete bootrec /scanos found also ZERO installations

 

Critical Process Died on windows 10 setup

Ive just opened event viewer as you suggested but I cant seem to find any error that says "critical process died"



I have attached a screenshot of the event viewer. I have scrolled to the bottom to where it first booted up.

Ive downloaded the software you sent the link for but I'm not sure how to use it as nothing shows up when I load it.