Windows 10: Critical Process died error bsod, tries to repair but fails, please help

I tried to boot up my computer this morning and it came up with the Critical_Process_Died on the BSOD, it restarted trying to fix the issue but then came up with another blue screen telling me that the PC did not start correctly, telling me that restarting it again might fix it. I have restarted it about 5 times now and I have had to same issue each time, even turning the computer on and off then on again in hopes of it working. I'm not exactly great with computers so please can you help me.

:)

 

Critical Process Died - BSOD

Hello,

There was a blackout, and upon starting my computer, I was greeted with the blue screen of death, with the only message being "Critical Process Died."

I attempted all the recovery options available:

• Safe mode gives the same error; critical process died
  
• chkdsk /r completed, but did not do anything
  
• SFC /scannow does not start. (Windows Resource Protection could not start the repair service.)
  
• DISM /image (disk) /cleanup-image /restorehealth does not start. It throws the error, "could not find file specified"
  
  • This command works when directed towards a disk with a fresh windows installation.
    
• System restore refuses to work.
  
• Resetting my installation refuses to work.
  

I've installed a separate windows installation to help troubleshoot.

• SFC scannow has the same response (Windows Resource Protection could not start the repair service.)
  
• DISM throws a different error: Error: 0x800f0801, DISM failed. No operation was performed.
  

How can I recover my PC without losing all my data?

 

BSOD Critical Process Died


This is my config, what should i do? - - - Updated - - - I tried also this: Step 1. From the initial Windows screen, accept the default settings for the language to install, the time and currency format as well as the keyboard or input method. Next, click the Repair your computer link instead of Install now. choose Repair your computer Step 2. Select Troubleshoot and then Advanced Options. Step 3. Select Command Prompt. Step 4. Type diskpart and press Enter key. Step 5. Type list disk and press Enter. Now pay attention to the disk number and identify which one is the boot disk. Usually, it is Disk 0; if not, find the disk number in your own case and remember to type the correct one in the following relevant steps. Step 6. Type select disk 0 and press Enter. Step 7. Type list volume and press Enter. Now pay attention to the volume number of the EFI partition. Step 8. Type select volume N and press Enter. Also, type the one in your own case instead of N. Step 9. Type assign letter=N: and press Enter. N: can be replaced by any drive letter that is not taken by any partition. Remember which drive letter you assign here for it is rather useful in the rest steps. Step 10. Type exit and press Enter to leave diskpart. Step 11. Now type N: (the drive lettered you just assigned) and hit Enter. Step 12. Type format N: /FS:FAT32 and hit Enter. Step 13. Type bcdboot C:\windows /s N: /f UEFI and hit Enter. Now repeat the process of running the bootrec /fixboot command, bootrec access is denied Windows 10 should be solved now. But if fixboot access is denied occurs on an MBR disk, continue with Fix #2. All steps until 13. was executed successfully, but still became on bcdboot /fixboot Error: Access is denied. And I have a GPT and no MBR Partition bootrec /rebuildbcd was successfully, founded Win installation: 0 (ZERO) complete bootrec /scanos found also ZERO installations

 

critical process died

Hello,

Please try suggestions mentioned here:

[FIX] CRITICAL_PROCESS_DIED BSOD In Windows 10

Hope this helps, Good luck