Windows 10: Cumulative update to 1909 may break IP networking?

Yesterday pc applied the latest windows update, I believe was a cumulative patch for 1909, bringing the build to 18363.592. Today, when I started to use the PC all networking came to a halt, and the computer made various complaints about misconfigured IP settings. Wifi was connected and ethernet had a link, but neither worked. I noticed that adapters in question had some new IPv6 addresses, but beyond that no idea what the problem was.

After a lot of wrestling, I rolled windows back to 18363.535 and some of the IPv6 stuff is gone and all the interfaces are operating normally. So it appears to have been the update.

I have a sister machine that I think has yet to be updated. But my newer laptop is running the build with no problem.

The previous major update basically locked me out of my computer and I'm not keen on it getting wrecked by windows update a third time in a row.

submitted by /u/Dougolicious
[link] [comments]

:)

 

Cumulative update issue

Hello!

As usual I checked for updates.. it showed a list to download and install.. After downloading, windows failed to install cumulative update for windows version 1909.. I tried to solve by using 'Have a question' option.. I tried every steps which were mentioned
in 'Get Help' window.. still no solution..

it shows

"There were problems installing some updates, but we'll try again later.

2020-01 Cumulative Update for Windows 10 Version 1909 for x64-based Systems (KB4528760) - Error 0x80073701"

please help me to solve this issue..

Thanks...

 

Network and internet

Hi,

Based on the details provided, it is also possible that your
TCP/IP
is not communicating with your network hub causing the IP conflict.
We recommend that you reset and reconfigure your TCP/IP.
Resetting and reconfiguring your TCP/IP
will help your network hub to communicate properly with your PC. To
reset and reconfigure your TCP/IP, follow the steps below:

Reset TCP/IP.

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh
    int
    ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your Network Connection.

Reconfigure TCP/IP.

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh
    int
    tcp set heuristics
    disabled
    
  • 
    netsh
    int
    tcp
    set global
    autotuninglevel=disabled
    
  • 
    netsh
    int
    tcp set global
    rss=enabled
    

Update us on how it goes.

Regards.

 

Windows 10 1909 Causes Secondary Hard Drive to not be Recognized

Installing the Windows 10 1909 Update causes my secondary hard drive to not be recognized.

Steps to confirm issue:

• Secondary drive not visible in Windows Explorer
• Secondary drive not visible in device manager
• Secondary drive not visible in disk manager

Steps to replicate issue:

• Installing 1909 update

Steps to resolve issue:

• Uninstall 1909 update

Since updates can only be delayed for so long, an actual fix would be appreciated.