Windows 10: Currently have an HDD and need to get windows 10 on new ssd

Hey guys I tried looking on Google to do specifically what I want and don't think I found it so I came here. I have a 2tb hdd as my primary hard drive and just got a 256gb ssd. I want to keep everything I have installed on the hdd such as my programs and documents except I want to move windows to an ssd. I don't know how to do it or if it's possible. Everything I've seen talks about either having a fresh start or cloning the whole hdd. Any help would be very much appreciated! Thanks!

submitted by /u/freddyaimfire
[link] [comments]

:)

 

Windows 10 on HDD to a new SSD

I have recently replaced the 500 GB HDD in my laptop running Windows 10 with a 480 GB SSD. The laptop was fully configured with my applications and other settings. The steps I took were as follows:

1) Shrink the C: drive so it was significantly smaller than the SSD (by at least 100 GB) using the Disk Management tools in W10.

2) Copy all the files from D: onto an external HDD.

3) Download Ubuntu Linux and burn on to a DVD.

4) Download Windows 10 from Download Windows 10 and burn this on to a DVD.

5) Close down and boot the laptop from the Ubuntu DVD from step 3 (I used a USB DVD rewriter).

6) Plug in the external HDD.

7) Open a Linux terminal and cd to the external HDD.

8) Copy the C: partition to the external HDD using a command such as:

dd bs=1024k if=/dev/sda1 of=C-drive

where sda1 is adjusted to point to the correct partition.

9) Close down and remove the external HDD.

10) Remove the HDD and replace with the SSD.

11) Perform a clean install Windows 10 from the DVD from step 4. Deleting all partitions from the SSD if it has had any created on it. When it asked for the product key, there was an option to enter it later. Make sure that the C: drive that is created is
the same size or bigger than the C: drive was on the HDD.

12) Repeat steps 5, 6 and 7 then run the command

dd bs=1024k if=C-drive of=/dev/sda4

With the clean install of W10 64bit, sda4 was the C: drive on the SSD after the installation.

13) Reboot from the SSD. The first couple of times my laptop reported errors and went into repair and diagnostic cycles. The last one said something like Reboot or Go to further tools. I cannot remember the exact messages but the meaning was as I have described.
I rebooted and Windows 10 came up and ran perfectly.

14) With the SSD working I shrank the C: drive a few GB to make sure the physical space was the same size as the actual filesystem.

15) Create a D: format it and copy all the saved files on to the new D: from the external HDD.

Job done. All my applications worked perfectly and the laptop connected to my wireless network without needing the pass phrase re-entering. I had tried several other ways of cloning the HDD to the SSD, but as the SSD was 20 GB smaller this was the only way
I managed to get it to work.

I hope this helps others to make the HDD to SSD transition.

 

Transfer currently installed OS to new SSD

Currently I have Windows 10 installed on HDD,

Now I want to change HDD to SSD

So how would i get the currently activated Windows to the new SSD ?

 

HDD to new SSD Question

I'm going to upgrade my laptop with a SSD along side my HDD which currently has windows 10 on it, or course. My question is, is it possible to move that version of windows 10 on the new SSD and boot it from there or do I just have to run a clean version
from the SSD?