Windows 10: DaveM121

I Dave, I am having this same issue and durgarao39 had back in Sept. I followed your answer to this issue that you suggested and below is what my results were can you help me to correct this window issue?Issue: Failed to connect to an IPC Port: The system cannot find the file specified. I need solve this problemYour reply to durgarao39: I am Dave, I will help you with this.Click your Start Button, then just type cmd, and on the resulting list, right click Command Prompt and choose 'Run as Administrator'Run these two commands in Command Prompt and press Enter after each commandNetsh winhttp sho

:)

 

Windows 11 Pending restart but I dont want it

Not in the installed list of updates ZakFardan1,

On the link you are following the steps listed by Abraham Andres Luna but you need to follow the steps by DAVEm121.

 

Please help me kill this zombie HomeGroup

DaveM121,

Thank you for the quick response. I tried the steps you suggested; no success.

 

windows 10 update problem

Eileen Gal-Gardenman-DaveM121, Once again, Thank you for all of your assistance with my problem with the most recent Win10 update.

I have completed the measures that Gardenman suggested and to no avail. I followed his suggestions step by step and after each download/install of a 'new' driver I'd wait for a few minutes to see if any changes took place and when there were none I restarted
the computer and the monitor display did not change. After each 'new' drive install I went back to the 'Roll back driver' location and it was no longer grayed-out. I even tried to initiate a roll back for each driver offered in the 'let me pick...' selection
and no change. After each install of a 'new' driver I would check the 'General' tab in the 'properties' box and it continued to indicated that 'No drivers are installed for this device'. Yet, under the 'details' tab, the ATI driver is listed as the 'device
description'. I have a large list of other indications shown in the properties box for the ATI driver, but I would just be repeating what I had previously listed.

I even went back and tried, once again, what DaveM121 suggested and no change.

Any more suggestions??? Thanks, Rixx (Rick)