Windows 10: Day 2 of this loop i should wait or do something?

submitted by /u/stfv_123
[link] [comments]

:)

 

Stuck in Getting Windows Ready Loop

I've tried all the suggestions listed in the community forum on the issue.

My loop started in the middle of my day, not after update. I waited two and a half hours, then turned off and tried these tips. Every time I turn it on, it returns to the loop.

What can I do?

Linda

 

Updates stuck at 65% and waiting to install for days

Hi,

Thank you for posting in Community.

We understand your concern and we will provide our assistance to help you resolve the issue.

As you have stated that you have already ran Windows Update troubleshooter and tried to run the updates in Clean Boot, I would suggest that you try the methods suggested below and check if it helps rectify your issue.

Method 1: Power Drain.

I suggest that you perform Power Drain as this will reboot your system and also remove the update loop that you are stuck in.

• Unplug the charger and remove the battery of your laptop, if using a desktop remove the power cord.
• Press and hold the Power button for 30sec.
• Plug the charger/power cord and restart system.

Once you reboot your system, restart the update and check if the same issue occurs. If the issue persist then, proceed to check for services.

Method 2: Windows Services

I would suggest that you check if the services associated with Windows Updates are enabled. To do so follow the steps below.

a. Press Windows key + R, type "services.msc" in start run box and press
Enter.

b. Locate Windows Update service.

c. Right click on the Windows Update service and select
Properties.

d. In Start-up type, select
Automatic.

e. Click Start under Service status.

f. Click OK.

g. Repeat the steps c to f for the following
services also:

Background Intelligent Transfer Service, Windows Installer & Cryptographic Service.

Note: The startup type for Windows Installer will be greyed out by default.

Hope this information helps

 

Mouse stopped working 2 days ago

Hi,

There are a lot of possible reasons for this matter to occur. One possible cause is your
drivers
might be
outdated
or the issue is within the
device/hardware
itself. However, we need to make sure that it is the case. To isolate the issue, we have
some questions for you:

• 
  Were there any changes made before the issue occurred?
  
• 
  Have you tried downloading and installing the latest driver update available in your computer/laptop manufacturer's
  website?
  
• 
  Have you tried using the device to another computer?
  
• 
  What troubleshooting steps have you done so far?
  

We suggest that you perform these
methods of troubleshooting
and check if there are any changes:

Method 1: Run Hardware and Device Troubleshooter.

To run the Troubleshooter, follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on
  Hardware and Devices
  to run the
  Troubleshooter.
  

Method 2: Update your drivers.

To know how to update your drivers, click
here.

Method 3:
Run SFC Scan.  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

If the issue persists, we suggest that you contact your
Device Vendor manufacturer
for further assistance.

Update us on how it goes.

Regards.