Windows 10: Dead HDD and windows won't open anymore. Wants to have a new os installed on SSD activated.

I have upgraded my windows 7 to windows 10 prom my laptop HDD is no longer working and wants to use the sdd to replace dead HDD. How can I make it activated?

:)

 

Install of Win 10 from old HDD to new SSD

My PC has a WD 1 T HDD as the primary drive with Win 10 installed. There is also an 2nd older WD HDD for data storage purposes if ever needed - unlikely.

I recently bought a new 500 GB SSD drive. I would like to install my WIN 10 on the new SSD using it as the primary drive.

To install on the new SSD, would I unplug the WD 1 T HDD and install the new SSD drive on the MB and then install Win 10 on the SSD.

After the above, I assume I then reconnect The WD 1 T HDD. With the OS on the New SSD, will the apps and programs that are on the WD HDD operate or will I have to reinstall them on the new SSD As well how do I delete Win 10 from the HDD - do I simply delete the files or delete the partitions or just don’t bother. The WD HDD a was not even close to being full and was bought for faster access.

Any suggestions on how to get the new SSD to work properly and windows off the old WD HDD so it does not interfere with the new SSD would be appreciated.

 

Switch HDD to SSD + Add m2 2280 SSD then Activation? Or Activate then swap all the HDD/SSDs around?

Good Afternoon,

Just purchased a brand new desktop PC (it still in the box). Its preinstalled with Windows 10 Professional (awaiting activation) on the a single drive which is a 2.5" HDD. I don't' want that drive in the computer and I've purchased two new SSD's to upgrade
the system. Once I remove the HDD, its no longer part of my equation.

Current out of the box setup:

2.5" HDD with Windows 10 Pro awaiting first startup / initiation and activation.

Where I want to go:

M.2 2280 SSD as Primary drive with Windows 10 Pro installed and activated here

2.5" SSD as secondary drive for my files/documents/data.

How do I get the preinstalled Win10Pro off the HDD, and activate it on the M2 SSD as the primary OS boot drive? Should I activate windows before making all these hardware changes? Or should I clone/reinstall Windows 10 Pro to the M.2 SSD then activate?
Last step is adding the additional SSD for data, but that's not a priority … or is it? Add it before activation?

This is the headache I get for buying an pre-built system that wasn't originally spec'd the way I wanted. Oh well.

Do the HDD/SSD changes make a diff to the activation process? or is it all hardware encoded to the motherboard which remains unchanged?

Advice?

 

OS on new SSD, keep existing data on HDD and use as external drive

Hi,

use steps you suggested, there should be no problem.

Just replace HDD with SSD first then run installation. Do not forget to remove Windows files from HDD after the end of a process.