Windows 10: Default Location--error message, location not recognized.

I've an end unit townhouse. When I try to type in my home address, the correct address comes up in the list based on the house number, but I get the error message: "location not recognized, select another location." When I look at the map, my neighboring townhouses are all shown in their correct locations, but my house number is floating off in the parking lot, not associated with a building.See 2420 Cloudcroft Sq, Reston, VA.

:)

 

FS/FT Thread title location

One more suggestion for B/S/T forum is the inclusion of a location made mandatory.
I know it's already possible, but there's a limited choice in locations, and not many people use it, assuming that because they're in the US, they don't need to.
The problem from this comes when they state quite clearly (although sometimes not clearly at all), they only ship to the US.
Making location mandatory in the thread title would save a bit of time and hassle, and would make searching the forum easier.

A suggestion for this: use the poster's location, if they've added a correct location, as the default.

It's not like it's an issue of privacy, the poster will tell where they're from within the post in a round-about way.

Not a big suggestion, but I thought I'd throw it in there.

 

Location

Hi Paul,

Wrong region settings or corruption may be the possible reason why a location was not correct or showing a different state. To assist you better, we'd like to gather more information:

• Have you made any recent changes prior to this issue?
• Are you getting any error messages when you tried to change it to the default location?

Meanwhile, we suggest that you follow the steps in this article to troubleshoot Cortana.
You may expand each section and try performing the instructions that you have not yet done.

Let us know if you need further assistance.

 

Location

Hello Lisa,

One possible cause is that these applications base the location from your Internet Service Provider's IP location. Furthermore, for us to better assist you, we'd like to know the following:

• Confirm which build is currently installed on your device. To check, follow the steps below:

• Press Windows key + R, then type in winver.
• Click OK.

• Have you tried setting you default location under Settings? To check, refer to the steps below:

• Press Windows key + I, then select Privacy.
• Go to Location. Under Default location, click on
  Set default.

• Which browser are you using to access the said websites?

We look forward to your response.

Regards.