Windows 10: Delay on Sleep/Wake after Closing/Opening Lid - HP Laptop - Windows 11 Home Single Language...

Hello Microsoft Community,I am experiencing a persistent delay issue on my HP laptop as seen in the BIOS information previously: HP Laptop 14s-fq1xxx running Windows 11 Home Single Language, version 24H2, specifically when closing and then opening the laptop lid.The problem occurs when I close the laptop lid, and upon opening it, there is a noticeable delay before the Windows login screen appears. The screen remains black for a period of time, and sometimes it doesn't even appear at all, similar to the initial issue I described earlier where the screen would stay black.I have already tried t

:)

 

Laptop does not wake from sleep using mouse and keyboard when the lid is close, but can wake when the lid is open.

Hi, so followed all of the instructions and these are my experiences:

• I tried to close the lid and do what you've said like pointing the cursor to recycle bin and it works, after i did the folder was open. However, this is because when I close the lid my laptop still not in sleep mode. So i waited for it to sleep and see the light blinking then i tried clicking and there was no response.
  
• Then, I tried the clean boot. Step by step as per instructions but nothing works. Still experiencing the same problem. I'm really wondering why, now i connected the hdmi cable and working with the monitor "Second Screen Only". The laptop lid is open and everything is working properly, I close the lid and still working fine. I tried to put it asleep but the mouse or keyboard can't wake the screen. Then I tried the same set up, second screen only, then put it asleep while the lid is open. Touch the mouse and my laptop was wake immediately.
  

 

Delay sleep when laptop lid closes

Is there a way to delay sleep when I close my laptop lid (similar to the mac)? It's not essential, but it's annoying to have to wait for the computer to wake up and sign in every time I close the lid. I want to delay the sleep by about 60 seconds.

I've tried setting sleep to 1 minute and do nothing when lid closes, but that's annoying for other reasons.

On a completely unrelated note, is there a way to make the battery percentage show next to or in the battery icon?

 

Laptop tries to wake from sleep while lid is closed.

Hello,

I have a Gateway NV53A with Windows 10 Home installed. When I close the lid, it goes to sleep normally for a few hours, but after a few hours it will start to get caught in a never ending "wake up loop" i.e. the laptop will try to wake itself up before quickly
realizing that it can't because the lid is closed. The DVD drive will continuously start to spin up each time. This happens every two or three seconds. The sound of the DVD drive trying to spin up every three seconds is annoying and it also wastes battery.
Normally, I have to hit a key on the keyboard to wake up the laptop after opening the lid again, but when it's in one of these wake up loops, it successfully wakes itself up upon opening the lid (evidence suggesting it's indeed trying to wake itself up.)

I've tried using the command line to see what devices are permitted to wake up the device, but none were listed. I've also disabled wake on LAN.

The only clue I've been able to find is an error in the system log that reads: "The system firmware has changed the processor's memory type range registers (MTRRs) across a sleep state transition (S4). This can result in reduced resume performance."

However, I'm not sure this pertains to the specific issue I'm having.