Windows 10: Device Security > Disk Health > CHECK DISK Problem

Hello Microsoft-Community,I had, several times ago 1-2 month ago, a problem that was displayed a warning sign instead a green sign in the taskbar under the symbol from the microsoft-security-center. In the security-center under 'Device Security' there appeared every start a massage that I needed to 'dismiss' I talked to the microsoft support and they guided me with the 'remote control support' I asked how this was happening and they said that it could be an error and I just need to dismiss it. After I dismissed the warning it didn't appeared again.I guess this was happening because my d

:)

 

Checking Disk Consistency

Ok i did as viper suggested, but it stops checking at stage 3. It is still saying the drive is dirty, and still needs to be checked. I did a defrag and a disk cleanup, and suggestions?

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

There is no disk in the drive. Please insert a disk into drive \Device\Harddiskvolume8

Hi Brad,

There are a lot of possible factors for this matter to
occur. To
isolate the issue, we have some questions for you:

• 
  Were there any changes made before the issue occurred?
  
• 
  Is this happening when loading a certain application or all of the application?
  
• 
  What troubleshooting steps have you done so far?
  

Kindly run the
Hardware and Devices
troubleshooter to automatically repair any issue it finds. To run the troubleshooter, follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on
  Hardware and Devices
  to run the troubleshooter.
  

After running the troubleshooter, perform a
check disk
and check if there are any changes. To perform check disk, follow these steps:

• 
  Open
  Command Prompt
  as
  Administrator.
  
• 
  Type
  chkdsk /r /f
  and hit
  Enter.
  

If possible kindly post a screenshot of the return message provided by the troubleshooter and the check disk command
if the issue still persists so that we can investigate this matter further.

We'll be waiting for your response.

Regards.