Windows 10: devices running off router

how do I find out what devices are running off my router

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Adding Routers and Printers to a PC running Windows 10 Pro


The way I would handle this is to reset the router, you at the moment do not know how the device is setup - DHCP could be disabled so there is no way it will auto allocate IP addresses

You will need to do some research as to ...

• The reset procedure - normally there is an inset button that needs to be pressed for a few seconds
• The administrator Name
• The administrator Password
• The default device IP address (the gateway address)

This information should be available online , (if not printed on the back / base of the device

Once you have this information a simple connection should allow access to the internal settings, Also you should check if a specific port must be used for this initial setup

If you are not sure of the way to proceed, post the full details of the router(s) involved and we will try to find and provide you with a step by step solution

 

wireless conection to router

Hi,

To better assist you, we would like to know the following information:

• Are you able to see the router's name in the wireless networks list?
• Are you able to connect to the router but unable to connect to the Internet?
• Do you receive any error message when connecting to the router? If yes, what is the exact error message that you receive?

In the meantime, we suggest that you run the Network troubleshooter. The Network troubleshooter can help diagnose and fix common connection problems. Kindly follow the steps below:

• In the search box on the taskbar, type Network troubleshooter, and then select
  Identify and repair network problems from the list of results.
• Follow the steps in the troubleshooter and see if that fixes the problem.

If the issue persists, kindly try the troubleshooting steps on the following link:

Fix network connection issues in Windows 10.

We recommend that you try the steps on the Update the network adapter driver,
Run the Network troubleshooter followed by networking commands,
Temporarily turn off firewalls and Use network reset to reinstall network devices sections.

Let us know how it goes for us to assist you further.