Windows 10: Disabled regedit and Group policy snap-in from one of the Admin account group policy. How...

Disabled registry editor and Group policy snap-in through one of the Admin account from group policy. How to re-enable either one. Please advice.

:)

 

GROUP POLICIES IN WINDOWS 10

You can change Group Policies by opening Group Policy Editor first. You can open it by following these steps:

• Log in an administrator account. If you are already logged in as an administrator, proceed to step 2.
  
• Press Windows + R to open Run.
• Type gpedit.msc and press Enter.
  

After opening Group Policy Editor, you can now make the necessary changes that you want.

Should you have more concerns, feel free to post.

Regards.

 

Windows Defender Group Policy Disabeled

Hi,

Thank you for contacting Microsoft community.

As you have stated you want to disable the group policy so that you can run windows defender on the computer.

I would like to suggest few troubleshooting steps:

Method 1: Disable group policy from gpedit.msc

• 
  Press Windows key + R.
  
• 
  Type gpedit.msc and click Ok.(it will open Local Group policy editor)
  
• 
  Go to Computer Configuration/Administrative Templates/Windows Components/Windows Defender.
  
• 
  In the right pane of
  Windows Defender in Local Group Policy Editor, double click/tap on the
  Turn off Windows Defender policy to edit it.
  
• 
  Select (dot) Not Configured or
  Disabled, click/tap on OK,
  
• 
  When finished, you can close the Local Group Policy Editor if you like.
  

If the issue still persist you can follow method 2.

Method 2: Disable group policy from registry.

Important: This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow
these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the
article in the Microsoft Knowledge Base:

How to back up and restore the registry in Windows

http://support.microsoft.com/kb/322756

• 
  Press Window Key +R.
  
• 
  Type regedit and click. (it will open registry)
  
• 
  Go to HKEY_LOCAL_MACHINE\SOFTWARE\Policies\Microsoft\Windows Defender
  
• 
  Right Click on Window Defender to create a new Dword.
  
• 
  Click on New and Select Dword.
  
• 
  Type DisableAntiSpyware.
  
• 
  Right click on DisableAntiSpyware and click on modify.
  
• 
  Set the value to 0 instead of 1.
  

Hope this information is helpful. If the issue still persists, you can write back to us and we will be glad to assist you further.

 

GROUP POLICIES IN WINDOWS 10

Just what i needed thank you.