Windows 10: Disk no longer showing in diskpart list disk, can't convert back to basic disk from...

So I've been trying to get a dual boot setup with Windows and Ubuntu but unfortunately I've botched it a bit causing me to have a hard drive I can't format or really access at all. The main reason is that before the installation, I wanted to merge a couple of unused blocks on the drive so I did extend volume on one of the partitions. Windows said this required it to be a dynamic disk for some reason so I clicked OK. I then installed Ubuntu on the other partition.During the Ubuntu installation, I was a little confused because it wasn't showing the two different partitions I made in Windows, onl

:)

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

Convert Basic Disk into Dynamic Disk

Hi Charbel,

It would be helpful if you mentioned the things that you have tried to do that failed so that we can skip those steps. You can follow the steps provided in the article:
How to convert a basic disk to a dynamic disk in Windows 7, to change a basic disk to
a dynamic one. The instructions are also applicable for Windows 10. You can also check this article:
Extend a basic volume.

Ensure that you create a back up for your system as well.

Regards.

 

Disk showing in Disk Management, But not DiskPart

Hello!

So, today I was doing a friend a favor, he had an old 1TB hard drive with important photos on it. He said he would appreciate it if I could move the photos to a different hard drive.

So, I hooked it up to my self-built PC (with a SATA port) and it didn't show up in file explorer.

So, I checked Disk Management to see if it would show up there, and it did. I later realized why it didn't show up in file explorer (Because it didn't have a drive letter). In Disk Management, I right clicked the primary partition only to find that it wouldn't
let me assign a drive letter.

I remembered there was another way to assign drive letters, with DiskPart. So I typed this into Command Prompt:

diskpart > list volume

In DiskPart, It showed the drive's EFI system partition (partition 1) but not the (Healthy) Primary Partition (partition 2).

Also in DiskPart, I could type "list disk" and it would show me the 1TB drive, if I then typed "list partition" it would show me the different partitions, but wouldn't let me assign a drive letter to them.

In summary, Disk Management showed the partition, but wouldn't assign a drive letter. DiskPart showed the partition 1, but not the primary partition.

My objective is to show the photos located on the 1TB drive's 2nd partition without erasing it.

I would be happy to add pictures if necessary.

Thanks!