Windows 10: Diskpart clean

Hello,I recently used clean command in diskpart and it is the only drive in my laptop and i installed windows in it. How do i get the files back?

:)

 

DISKPART CLEAN

Hello

I'm Peter F independent Advisor

You will get this error when you are using diskpart clean command on system disk. The system disk contains the Windows operating system files and other critical files, if you are allowed to clean the system disk, all the data and partitions will be gone. That
will result in a lot of errors and chaos. Meanwhile, the delete volume is greyed out in Disk Management. In this case, the new SSD drive may be regarded as the system disk due to the system files, etc.

Using Windows installation disc to clean

If you have the Windows installation disc, you can follow these steps to solve clean is not allowed issue in Windows 7/8/10:

1. Insert the Windows installation disc, then boot from it.

2. Click Repair your computer> Troubleshoot > Advanced Options > Command Prompt.

3. Then input the diskpart commands to clean hard disk:

diskpart

list disk

select disk [disknumber]

clean

Diskpart Clean

Then you could create a new partition on the drive to solve this problem.

Reference

https://www.disk-partition.com/articles/virtual...

This is a non-Microsoft website. The page appears to be providing accurate, safe information. Watch out for ads on the site that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised
on the site before you decide to download and install it.

I hope it helps

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

Use DiskPart to Create the OS Partition on Clean Install.

I have a Laptop HDD [ my preferred option as opposed to an SSD on this Laptop ] arriving on Friday and I want to use DiskPart to Setup the size of the OS Partition. The main reason I want to do it this way is because DiskPart can create an exact 30 GB Partition [ my OCD ] for example. Here are the steps that I tried the other day which did NOT work . . .

• Boot from the install USB.
• On the Windows Installation Screen press Shift + F10.
• diskpart
• list disk
• select disk 0
• clean
• create partition primary size=30000
• exit
• exit

I intend to leave assign AND format fs=ntfs for Windows to perform as normal during the installation.

Thanks.