Windows 10: Diskpart Help

I would like to write a batch file that uses diskpart to partition 6 partitions, assigns drive letters ,to 60 ,20,20,250,80 , 80,DVD and USB Flash and formats the partitions to NTFS . How is this done? John

:)

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks

 

Faulty harddrives

Thanks for the suggestion but as I stated the drive doesn't show up in Disk management. I just tried the Diskpart steps and it's not listed on there either

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!