Windows 10: Diskpart not working.

Hello, I have a Windows 7 home premium, if try to clear read only through diskpart, it says attributes cleared successfully, but when I check the attributes for the same disk again, read only is still yes. I need to format this disk asap. But I can't.

:)

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

diskpart for usb drive format is not working

when i used to make my pendrive bootable and it doesnt perform well and shows errors now the pendrive is not working and wants formating .So i m going to used cmd diskpart commands for clean the pendrive but when i opened the cmd by administrator and type
diskpart and enter after that the i couldn't type anything in the diskpart as my keyboards are not working nor the on screen keyboard does. please suggest me somthing to fix the diskpart problem.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!