Windows 10: Diskpart question

My volume 0 Ltr C is Windows partition is healthy/ Volume 1 no ltr label is system FAT32 shows hidden and volume 2 is hidden that is the Windows. How do I fix this?

:)

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

Faulty harddrives

Thanks for the suggestion but as I stated the drive doesn't show up in Disk management. I just tried the Diskpart steps and it's not listed on there either

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!