Windows 10: Display on screen blank

Display of laptop wont function, but if I connect an HDMI to the laptop screen shows. All projection options functioningextend to displays, duplicate displays, display screen 2 only all good except for display 1 which is the laptop monitor. Cant see anything in the screen if I restart unless I attach HDMI. Already installed new drivers. Please help

:)

 

Blank Screen

Hi Virginia,

Conflicts with third-party software and outdated graphic drivers are common contributors to the black screen issue that you're having. To isolate the said issue, we'd like to ask a few questions:

• Are you getting any error messages before getting a blank screen?
• Are you experiencing this when using a particular app?
• Were there any changes made on your computer settings prior to this issue?

Meanwhile, we suggest that you refer to this
article which talks about the steps you can take to resolve blank screen errors.

We'll wait for your response and assist you accordingly.

 

FIX SCREEN SO IT DOESN'T GO BLANK

Hi Charlotte,



Thank you for writing to Microsoft Community Forums.



I understand that the computer screen goes blank after sometime, I’ll certainly assist you with this.



However, please let us know:

• Do you see any error message on the screen when the computer screen goes blank?
  
• When you say “I need to fix it so that doesn't happen” how are you fixing the screen?
  
• What is the make and model of the computer?
  

Meanwhile, you may want to refer the troubleshooting steps mentioned below:



If you are using a Desktop, then the first thing I would suggest you to do is check if the cables are connected properly.



Method 1: Refresh Graphics driver



I suggest you to try refreshing the graphics driver by using the key sequence
Windows logo key + Ctrl + Shift + B and see if that helps.



Method 2: Update graphics driver



I suggest you to try updating the graphics card driver and see if that helps. To do this, refer the steps mentioned below:

1. Press Windows logo key + X, and select
   Device Manager.
   
2. Expand Display adapters.
   
3. Right click on the display driver and select
   Update Driver.
   
4. Restart the computer.
   

Article for reference: Update drivers in Windows 10.



Let us know how it goes.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Display Blank : Analog Input?????


My new PC has a blank screen with the message : 1. Analog input, cannot display this video mode.

I recently upgraded from Win8.1 to Win10 on my new Dell Inspiron. I have an older PC right next to it with WinXP. Both are using Dell flat panel digital displays. After the install I noticed that the default screen resolution made icons much larger than on the old PC with the identical monitor. So I attempted to change the resolution. When I set it at 1280x1024 to match the old screen, the icons were too close to the left edge and partly chopped off. So I reset it at the resolution suggested by Win10 (don't have access to the actual number, due to blank screen) but it was about twice the normal resolution. When it changed to the new resolution, the screen turned black and displayed the message above. Now my PC is unusable.

I don't know if the problem is with "analog input" or the resolution numbers, but I haven't found a way to go back to the original. I tried F2 and F8 and F12 during bootup. but so far found no way to change video display settings. F2 shows various setup options, but nothing about display. Holding F8 during boot-up goes to the blank screen instead of to Boot Manager or Safe Mode. The button on front of monitor does nothing.

I need help to return the display to its original settings. But without being able to see anything on the screen. Any suggestions?