Windows 10: Does anyone have a fix, I keep getting this BSOD

submitted by /u/P1wnk
[link] [comments]

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

BSOD issue after fixing another BSOD error

Hi Williams,

There are several reasons why BSOD occur, which has different resolution. To check for any corruption or the integrity of your computer's Windows, we suggest that you perform a
Check Disk by following these steps:

• Type cmd in the search bar.
• Right-click on the Command Prompt, then Run as administrator.
  
• Type chkdsk x: /r, the /r command will fix errors found on the disk.

Let us know if you need further assistance.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.