Windows 10: Does anyone know how to fix this bug besides from a full factory reset.

I have a bug where i can open the settings app but the home page is just a white screen with the search bar. however, when i use said search bar for setting clicking on any of the options will take me right back to the blank white page with my account at the top left and the onedrive, Windows update, rewards and web browsing in the top right with the windows update option taking me back to the white page. any solutions would be very helpful as i have tried every yt tutorial under the sun.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 factory reset

Hi Charlie,

We can see here that you are having issues with doing a factory reset on your Windows 10. There are several factors
why you get the said error and that's what we are going to figure out. To isolate this concern, may we know the following:

• Any changes made on the computer prior to this concern?
• What troubleshooting steps have you tried so far?
  
• May we know the reason why you want to perform a factory reset?
• Did you experience any issues on the computer before you tried performing a factory reset?
  

 

Diskpart : there are no fixed disks to show.. Factory reset gone awful

Hi everyone, I was asked to factory reset an Asus laptop and install a win 7 on it, while starting to install the win 7 I got stuck with the "no device drivers were found", searched for some tutorial on YouTube, found this vid: , followed the command codes step by step on MS-DOS : ( Diskpart >>> list disk >>> select disk 0 >>>> Clean >>>> create partition primary >>>> format fs=ntfs quick) and now I completely lost the disk 0 with all system files, no hard drive showing as a boot option in the BIOS. Am I screwed ? Is there a way to create or reactivate the internal HDD ?? Thank you in advance for your help