Windows 10: Does this setting reset for anyone else? I normally have it off but it always turns on...

submitted by /u/PananaBudding
[link] [comments]

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Overclocking / Undervolting guide for Vega 56 or 64?

Here's a quick laundry list:

List of software to use for overclocking and testing
Examples:
Wattman (and how to find and use it, like an overview, including profiles)
Unigine Valley or Heaven (use this for quick testing while changing settings in Wattman and checking for stability / artifacts) ...just suggesting this
How to monitor cores / mem speeds and temps during testing (I've seen screen overlays, and others using GPUz)

Step-by step overclocking in Wattman
Fan speeds
Power limit
Temp limit
Voltages
Core speeds
Memory speeds