Windows 10: Drive repair

When I start my computer it does a disk check every time. When I do the repair through the disk properties it scans, begins to repair it, but then starts regularly without me pressing anything. When I go to check the disk again it still says there are errors, but when I check the status of the disk under hardware, it says 'this device is working properly.' Is this a sign of underlying more complex errors, or do I just need to turn off disk checks?

:)

 

Im having a Repair C drive Errors.

Try This

Follow these steps to repair corrupt hard disk without formatting, and get back the data.

1. Step 1: Run Antivirus Scan. Connect the hard drive to a Windows PC and use a reliable antivirus/malware tool to scan the drive or the system. ...
2. Step 2: Run CHKDSK Scan. ...
3. Step 3: Run SFC Scan. ...
4. Step 4: Use a Data Recovery Tool.

 

repairing drive c

The part of process that you are in when updating Windows is the check disk (CHKDSK), the system is checking your drive for errors.

Are you still having the issue and stuck at Scanning and repairing drive process?

As a workaround, you can follow these steps to bypass the CHKDSK process:

• Hold down the power button for 4 seconds.
• The PC will reboot.
• You will get stuck again on the process, repeat step 1.
• You will get a message "press any key to bypass the chkdsk."
• Press any key and it will continue on the update process.

Let us know if you need further assistance.

 

Programs not working

In post 26 there were steps listed to fix the operating system corruption.
Are you able to follow them?
In post 29 was the suggested dism repair command.