Windows 10: driver and device

my pc can't connect to internet when i switch out " wi-fi mode " in my pc. i did tests/checks on "network connection" : A. i found the words " ethernet, Realtek PEle FE Family Controller, cable unplugged actuarily both ends of the cable plugged on screen. B. on 'hp supp. asst.' website : " wired LAN1, Realtek peie fe family controller status, not connected "


i can't resolve it after done my best. could you pls help ?

my pc :hp notebook, windows10, modem bgw210
pinglamxl


:)

 

Laptop driver/reformat question

This is excellent advice. Writing down the list of installed devices prior to re-formatting will save you a lot of heartache. With that list, you won't have to try to figure out exactly which wireless card or web cam driver you need since there will likely be several to choose from.

 

Taskbar bug: switching to another window -will not appear at the front


Follow either of these steps to fix the issue with the Active window hiding behind.

Method 1:
I suggest you to disable window by hovering over it with the mouse and check if it helps. To do so I suggest you to try the below given steps and check if it helps:

1. Press Windows key + X key and click on Control Panel.
2. Select or click Ease of Access.
3. Click or tap onEase of Access Centre.
4. Click on Make the Mouse Easier to Use was uncheck Activate Window by hovering over it with the mouse.
5. Check if issue is resolved.

Method 2:
I would suggest you to completely uninstall the touchpad driver and reinstall it. Kindly follow the below given steps.

1. Press “Windows key + X” and click on “Device Manager”.
2. In the list of devices, you should see the touchpad drivers.
3. Right click on the device and then select "Uninstall".
4. In the uninstall dialog, make sure you select the option to delete the driver package from the system. This causes the driver package installed earlier to be deleted.
5. In the Action menu of Device manager, select “Scan for Hardware changes” option. This will cause the device driver to be reinstalled. Once the driver is installed, close all windows and restart the computer.

 

synaptics Pointing Device Driver

Try Uninstalling your device first, restart and then Install again.

Step 1:

• Open device manager by right clicking This PC and select Manage. On the left pane, click the same.
• Under Mouse and pointing devices, right click the synaptics driver and click Uninstall.

Step 2:

Restart when prompted. Remember, Restart!

Step 3:

Install the synaptics driver again using the setup utility provided by the manufacturer