Windows 10: Driver related ntoskrnl.exe causing BSOD after new motherboard, CPU, and ram install

Hi everyone,I just installed a new Aorus 590 Elite AX mobo, an intel i5 11600k, and 32gb of RGB vengence Ram. However I'm having a lot of issues getting new drivers installed, and a LOT of BSOD's that say driver power state failure. Using this website: https://www.wintips.org/find-out-which-driver-cause-windows-to-crash-with-bsod/#I tracked it down to ntoskrnl.exe causing the BSOD, and I've been trying to figure out what to do with that info, but no luck so far. I've tried a memory test with no issues coming back, and I'm at a bit of a loss. I can boot it just fine in safemode, so it defi

:)

 

Ntoskrnl BSOD

• Update your Realtek audio driver.
• Update your computer.
• Disable overclocking settings.
• Turn off BlueStacks/ another Android emulator.
• Clean your registry.
• Check your disk for errors.
• Fix bad memory issues.
• Remove faulty sticks of RAM.
• I hope these methods help you!
• Regards,
• Lewis
  
  * Added by Moderator: Information from
  https://windowsreport.com/windows-8-bsod-ntoskrnl-exe/
  
  * Moderator note: Advice given on this page might or might not be safe and/or effective but there are programs usually classified as PUP's (Potentially Unwanted Programs) being pushed that should not be downloaded or installed.
  

 

BSOD ntoskrnl..exe+1b35e0

Hi, KirbyBakken

My name is Maritza and I am an Independent Advisor. I would be happy to help you today.

Check this link, I hope it helps

https://www.thewindowsclub.com/ntoskrnl-exe-hig...

Note: This is a non-Microsoft website. The page appears to be providing accurate, safe information. Watch out for ads on the site that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised
on the site before you decide to download and install it.

Let us know if these steps help you to resolve the issue.

 

hardware_disk bsod

The minidump points to ntoskrnl.exe which is the Windows NT OS kernel. This can be a hardware or software issue, but it is best to rule out the drivers first, then look at hardware related errors.

This guide has a comprehensive list of tests to do to isolate the issue and if followed should figure out whether it is a an issue with faulty ram or hard drive, or if it is as simple as updating the drivers. Unfortunately you could be looking at a faulty ram
stick or a failing hard drive, and very rarely a bad capacitor on the motherboard, but take it all one step at a time and see if the issue is easily fixable

https://www.auslogics.com/en/articles/fix-ntosk...