Windows 10: Driver SD Card doesn't work, code 10 error

Dear,

When I insert my SD card in my laptop, it doesn't pup up in my hardwares (it does in another devices). I can't fixed the problem, tried already software updates and fixing problem functionality in Windows.

See attachment.

Hope you guys have a solution for it.

Kind regards,
Lale

:)

 

Windows doesn`t start. Authomatic repair doesn`t work.


Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?

 

SD card reader problem after updating to Windows 10

After installing windows 10 my card reader will not oper but it does make noise like it is going to open but it doesn`t open it

 

SD card failure

Hi Andrew,

I would need to ask few questions so I can isolate your concern properly. Kindly answer the following:

• Did you get a specific error message?
• What are the troubleshooting steps you have done so far?
• What's the current build of your computer? Press Windows key + R and then type winver.
• Did you try to run a full system scan using your anti-virus? Can you tell us the result?
• Does your SD card has a write protection?

Meanwhile, you may try these troubleshooting steps:

Step 1: Run the Hardware and Devices troubleshooter. Open Settings> Update & Security> Troubleshoot> Hardware and Devices> Run the troubleshooter.

Step 2: Check SD Card in Disk Management.

1. Open Disk Management.
2. Your SD card will appear as a removable disk.
3. Check if it has a drive letter.
4. If it does not show anything, right click the SD card and then select “Change Drive Letter and Paths”.
5. Click “Add” and select a drive letter, then click “OK”.

Step 3: Update SD card driver.

1. Open Device manager.
2. Find your SD card and right click it.
3. Select Properties.
4. Click the driver tab and then select Update Driver.

Note: You may need to use a keyboard and mouse to connect to your laptop to perform the said steps if it does not allow on tablet mode.