Windows 10: Driver_Verifier_Detected_Violation Blue screen Loop

So yesterday I installed a new nvidia game-ready driver from their application and i’m using a Dell G15 Ryzen edition gaming laptop. I noticed that after the driver was installed my fps in my games dropped from the 200 normal to around 100. Other than that, it was running fine and I didn’t have any issues restarting it, etc. I went to sleep and woke up the next day to a blue screen and an error code Driver_Verifier_Detected_Violation and at first it was putting my pc into recovery mode after every 2 restarts and I was playing around in it trying to find where to disable my driver verifier i g

:)

 

DRIVER_VERIFIER_DETECTED_VIOLATION blue screen error on Windows 10

Hi Diki,

Welcome to Microsoft Community.

I understand that you are getting DRIVER_VERIFIER_DETECTED_VIOLATION blue screen error on Windows 10. I will certainly help you.

DRIVER_VERIFIER_DETECTED_VIOLATION blue screen errors can be caused by a variety of hardware, firmware, driver, or software issues.

In order to assist you better, please reply to the following questions.

1. Are you able to boot to desktop?

2. Did you make any hardware or software changes prior to this issue?

3. Have you installed all Windows Updates?

I suggest you to go through the below article and follow the steps given.

Troubleshoot blue screen errors

Please post back with requested information and we will be glad to assist you further.

 

Driver_Verifier_Detected_Violation Blue Screen

Hi,

I understand the inconvenience caused, I will be glad to assist you with this.

This could be due to faulty RAM, hardware failure or corrupted or outdated driver.

I suggest you to try the troubleshooting steps provided in the help article below and check if it helps.

Troubleshoot blue screen errors

Let us know the result, we will be glad to help if you need further assistance.

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.