Windows 10: Drives selection for system image

Hi. I am trying to make a system image but I'm troubled with something i haven't experienced before.When I installed windows on my current PC, i had all system files installed on an SSD which is Disk C. That's the only disk i actually care about for the system image, as i only use it for my system files and installing all programs and applications i actually use on a daily basis, excluding games and other non essential stuff. All the bulk storage is distributed between HDDs internal and external.When I check all my disks, Drive C has about 170 Gb of used storage and I'm trying to make the

:)

 

Unable to use System restore from a windows 10 image on Windows 7 with error: "windows cannot find a system image-the usb drive is not visible"

Hi Otley,

Thanks for replying to us with the status of your issue.

As you mentioned, when you connect the USB flash drive in to the system then the System image backup is not present. It might occur if the System image files is not created properly or may be it got corrupted.

As an initial steps I suggest you to check for the memory space in the USB flash driver.

If the Memory is occupied in the USB flash drive the I suggest you to try running check disk on USB flash drive and check if it helps.

Follow the below steps to perform Check Disk.

• 
  Press Windows + X on your keyboard.
  
• 
  Select Command Prompt (Admin).
  
• 
  Type the below commands.
  
  Chkdsk [drive letter]: /f /r
  

Reply to us with the status of your issue, we will be happy to assist you.

 

Unable to use System restore from a windows 10 image on Windows 7 with error: "windows cannot find a system image-the usb drive is not visible"

Please help me restore windows 10

 

System Image Problem

Hi Nick,

No need to stress.
Since the dl of the windows install media failed twice in a row already we are going to do as Bill suggests.
No use wasting another day on it at this point.

Here is a description of the steps to follow:

- Connect the external drive that contains the Macrium images we made.

-Boot off of the Macrium rescue CD. Make the necessary changes in bios so booting from CD is the highest on the boot order priority list or use the machine's bootmenu (Fn key ? ) to select to boot off of CD.

- From within Macrium select restore. Browse for image 0_SysRes etc. and load it in Macrium.

- Select the drive to restore to: your c: drive. Make sure it is the correct drive. Only one internal drive should be connected at this point.

-Drag and drop the loaded backup image to the beginning of the C:\ partition. It must be fully at the left of the partition.

- Click restore and confirm.

- Once it has finished close Macrium. It will automatically reboot.

-Boot again off of the CD.

-Macrium loads and select restore again.

-Browse for and select 1_Windows from the backup drive. Select the same destination drive and drag and drop it right next to the small partition we just restored. Click restore, confirm the overwrite and let it finish.

-Again close Macrium and reboot once more off of the cd.

-In Macrium on the top left hand side there a menu option that reads something along these lines (I'll load it in a few minutes to verify and correct if necessary) : "Fix Windows boot problems".
Click it.

-Let it finish and reboot off the main hard drive this time.

- Cross your fingers and hopefully Windows will start up.


I suggest not doing this immediately. I hope Bill will have a look at the suggested steps and correct any if need be.

Best, *Wink