Windows 10: During windows installation through bootable usb drive, the windows booting files get...

I formatted my pendrive and then made it bootable and used it for windows installation, i am concerned about that will my deleted data from pendrive also get transferred to the device where i have installed the windows from bootable usb drive.

:)

 

Multi-bootable USB

Hey guys from TPU, couldn't find any specific thread pertaining to the question asked on title. As mentioned, I'm trying to create a bootable USB, but with many specifics boots available.

I've been trying to create one with multiple boot device including one that enables me to run Windows 10 directly on the USB Thumb Drive but to no avail.

The list of bootable images i'm trying to create are

1. Windows 10 (A full OS running from thumb drive)
2. Windows 10 ISO (Bootable disk image for fresh install)
3. MemTest86+

Have tried YUMI or UUI from the website USB PenDrive Linux but as this is my first time, i don't know how am i screwing up or am doing it right.. Anyone got a rough idea on a step by step guide? Thanks!

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

Installing Windows 7 via USB flash drive!

Its weird tho cause I have no problem with installing from disc. I did change it back to boot from HDD. I really dont want to uninstall all my components, kinds defeats the purpose of installing from usb. it would take longer to disconnect and reconnect after install then it would to just install from dvd.

Do you think its beacuse the drive was formated in ntfs, thats the only step I did different from the OP. Well that and the bootsect /nt60 command before coping files.

heres they way I went, probly have to try it fat32

launch diskpart.exe)
select disk 1 (or your USB drive number, use list disk to get it)
clean
create partition primary
select partition=1
active
format fs=ntfs
assign
exit

Now that the drive is boot aware, we have to initialize its boot sector with the Windows boot manager (BOOTMGR), using the Bootsect.exe utility located in the boot directory of the Vista installation DVD. We have to tell the utility that our target drive is NTFS formatted:

bootsect.exe /nt60 f: