Windows 10: eMMC driver in Windows 10 supported on eMMC5.1 ?

I would like to check whether the eMMC driver from Microsoft is supported on eMMC5.1 (eg: Sandisk, SDINBDG4-64G-I1)


Thanks

:)

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

DTS supported natively by Windows 8/8.1 and it should work on windows 10 too just DDL require to unlock your driver .

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

Everyone that post ids, need just do these steps and you will be good. I kinda tired of keep on uploading the inf. file

1.Go Open up device manager
2. Go under sound,video, and game controllers
3. Find Realtek High Definition Audio
4. Right click and hit update driver
5. Browse my computer for driver software
6. Let me pick from a list of available drivers on my computer
7. Click Have Disk and hit browse
8. Click on the Realtek HD Audio mod folder and look for win64
9. Click on the HDXRT4 and click ok,
10. Click Next and Yes
additional if you want dts audio and others, install it now before next step.
After it is done, restart the PC

You should be good then and also make sure before doing these steps that you have driver enforcement disabled.

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

For those who just need to enable Dolby Digital Live 5.1 for your realtek sound card here is complete manual. Works for me in Win 10 Creators update (1703). Easy installation if you do not need these Dolby things just allow DDL 5.1

Here is the post #27
https://www.techpowerup.com/forums/...by-digital-live-dts-interactive.228612/page-2
and here is the link for Realtek R2.80 driver doownload (can not be found on Realtek official site)
https://mega.nz/#!sgQBEABb!mbbsYWiLCWRFYICNN_1zplUjyFQ1VSeFb-krdStOvZM

You also need to enable Test mode before installation of the driver.

Enable Test mode:

Step 1. Open the Windows command promt as "Run as Administrator".

Step 2. Run "bcdedit -set loadoptions DDISABLE_INTEGRITY_CHECKS" (without the "").

Step 3. To finalize the process run "bcdedit -set TESTSIGNING ON" (without the "").

Step 4. Reboot and you're done.

To disable it do step 1 and run these commands on step 2 and 3:

Step 2. "bcdedit -set loadoptions ENABLE_INTEGRITY_CHECKS" (without the "")

Step 3. "bcdedit -set TESTSIGNING OFF" (without the "")

Then do step 4 and you're done.

Then you can continue to installation of the driver.

I hope I helped you, if any questions, ask here I'll try to answer you if I'll be able.