Windows 10: Error appears when shutting down my computer after installing anything.

The error code is “The instruction at 0x00007FF C57663ACA referenced memory at0x0000000000000024. The memory could not be written.”. I have tried multiple methods to try and get rid of the error code and they only work until I download something else. If anyone is able ti possibly help me out I’d very much appreciate it.

:)

 

STOP error after Windows MCE 2005 clean install

OK, found the rest of it.

A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you've seen Stop error screen, restart your computer. If this screen appears again, follow these steps:

Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard drive and make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.

Technical information:

*** STOP: 0X0000007B (0xF7C7B524, 0XC0000034, 0X00000000, 0X00000000)

 

Error message appear after installed softmod driver

hey all,

As the title suggest i am having problems with softmod driver. Now it started givin me warning with following output.

Event Type: Error
Event Source: ati2mtag
Event Category: CPLIB
Event ID: 52225
Date: 18/07/2005
Time: 14:07:18
User: N/A
Computer: *********
Description:
CPLIB :: Open Session - Failed to load the library
------------------------------------------------
It's no such error if I install official driver. Older ATI drivers where removed before installation with driver cleaner.

System: AMD1700+, KT266A with 4in1 4.43, 512M, ATI 9500

 

Won't shut down or restart -- error X0X

Hi,

Thank you for posting your query in Microsoft Community.

To assist you better, I would like to ask what are the methods that you have tried to solve the issue.

The issue might occur if the computer is not shut down properly. so, I suggest you to perform a power drain by follow the steps below and check if it helps.

• Shut down the Computer.
• Remove all power source (including battery if it is a laptop).
• Press and hold the power button for 15-20 seconds.
• Connect the power source and start the computer.
• After the computer boots to the desktop, suggest you to install all the pending updates.

Hope this helps. Keep us posted on the status for further assistance.