Windows 10: error microsoft creation tool

to resolve the issue I was able to do it using two methods:


1- format the USB drive and create GPT partition. I used easeUS to do that,


2- Disable the secure boot in the bios.


and RUN the tool as an administrator.


Both solutions were successful and I was able to create the windows 10 1809 bootable USB with no errors.


Good luck

:)

 

Microsoft Passport errors during PIN creation


Microsoft Passport errors during PIN creation

Source and more: https://technet.microsoft.com/en-us/...g-pin-creation

 

Windows Media Creation Tool Error 0x80070079-0xA001A

Your USB thumb drive needs to be at least 8 GBs.

The error code 0x80070079-0xA001A means that the tool doesn't have permission for it to run. For us to assist you, we suggest that you
follow the simple steps listed below:

• 
  Right-click on the Media Creation Tool.exe.
  
• 
  Press Properties.
  
• 
  Click on General.
  
• 
  At the bottom, click on Unblock.
  
• 
  Press Apply, and then OK.
  

Let us know how it goes and if you need further assistance, feel free to post back.



You can also download the ISO first using the Media Creation Tool, then create a bootable copy. Yes, you can use it to perform clean install.

If Windows 10 was already installed and activated on your system, just proceed to perform a direct clean install as described in the following articles.

Step 1: How
to download official Windows 10 ISO files

Step 2:

• How to: Perform a clean install of Windows 10

 

Media Creation Tool question


Hi, I have never had any problems using the Media Creation Tool to perform a Windows 10 clean installation until yesterday so I have a couple of questions.
1. The tutorial here says after going to the Microsoft site and selecting the Download Tool (Media Creation Tool) option that the Media Creation Tool should be save to the PC and run from there.
On Microsoft site the instructions are to Download the Tool and select Run (no saving to the PC). Is there a reason for saving it to the PC first as suggested on Tenforums?

2. Yesterday I used the Media Creation Tool to do a clean install. Everything went fine with the download. After the two hour download the Media Creation Tool automatically started to create the media. Everything working normally so far..then suddenly at 50% a screen popped up with an unexpected error message Error code beginning 0x80004005. That was it I had to stop there.
After searching the net it seems that other people have had the same issue after the Fall Creators Update...with the installation stopping at 50%. I have no idea how to sort this out. After contacting Microsoft Chat Support they didn't offer any suggestions that worked either.
Can anyone advise please
Many Thanks