Windows 10: Error: no such device

Hi, I'm sending this from my mobile device. I tried inserting a new ssd into my computer, but found I didn't have the space in my pc. This wasn't a problem, I just put the back on the pc and tried to boot. Instead of booting I got the message:error: no such device: 2575e4b8-cf10-4bfd-b79c-a90f339845d9. error: unknown filesystem. Entering rescue mode…I belive I may have also knocked a cable out, see picture of it below. The old ssd was plugged in for a brief period and it contained Linux. Any help?Images:

:)

 

Error: No work available to process

Hmm. Either it's put out errors and WCG is limiting the work units available, or the project list may not be set to supply other WU when one runs out. (if the problem lies here and not on your end)

On the options to your left, if you go into Results Status, select the computer from Device Name and then look through results see if either they were returned late, errors or any other kind of issue that would stop the servers supplying WU from that perspective.

If there are no errors then it's maybe down to your project list. So selecting Device Manager from the left menu and then clicking on the profile assigned to that computer and make sure that it's assigned to receive WU for other projects if they run out.

At least those steps will rule out problems from the WCG end.

 

Error 10 (device doesn't start) while trying to load a VCP to a USB serial converter on Windows 10

HI Joost,

Thank you for posting in Microsoft Community and being a part of Windows 10.

I understand your concern about accessing the USB device on your computer. Do not worry we will help you with this issue.

Do let us know the following to assist you better with this issue:

• Is this issue specific to the device (Are you able to connect any other device to your computer)?
• Were you able to see any error code/ error message along with Error 10?
• What is the make and model of your device?

Try the below troubleshooting steps and check if it helps.

Step 1: I suggest you to run Hardware and Devices troubleshooter as it checks
for common problems and makes sure that any new device or hardware connected to your PC is installed correctly.

• Press Windows key from the keyboard, type
  Troubleshooting and select it.
• Click on view all option on the upper left corner.
  
• Select the Hardware and Device options from the list.
  
• Click Next to run the Hardware and Device
  Troubleshooter.

Step 2: I suggest you to refer to the Microsoft support article, refer to the section Error code: 10, try the troubleshooting steps suggested and check if it helps.

Error codes in Device Manager in Windows

Step 3: I suggest you to download and install the pending updates on your computer.

Steps:

• Connect to the internet.
• Press Windows key and type
  updates.
• Click on Check for updates.
• Under Windows Updates, click on
  Check for updates.
• Try to install the updates being shown.

Hope it helps. Get back to us with an updated status of this issue for further assistance.

 

Radio Switch Device Error Code 19

Hi Kara,

Thank you for bringing up your query on Microsoft Community.

We sincerely regret for the inconvenience caused, and appreciate the steps you have taken so far to fix this issue.

The error code 19 describes that, Windows cannot start this hardware device because its configuration information (in the registry) is incomplete or damaged.

Recommended resolution

• Uninstall and reinstall the driver.
• Revert to the most recent successful registry configuration.
  

Before we could reset the computer to factory settings, I suggest you to refer to the below article and perform the troubleshooting steps suggested for error code 19.

Error codes in Device Manager in Windows.

Error codes in Device Manager in Windows

Hope it helps.

Let us know the status, we are happy to assist you further.