Windows 10: Ethernet disconnecting when using 1 Gbps

Whenever I use 1Gbps on my desktop my ethernet keeps disconnecting for a bit then comes back after a while. What do I do

:)

 

1 Gbps internet

I recently upgraded to 1 Gbps internet from 100/100 Mbps. Both of my computers run Win 10 Pro 64 bit systems. They are both connected via wifi and both have recorded speeds at around 100 Mbps using wifi. If I use an ethernet cable directly from the router
I get almost 987 Mbps. Why the big discrepancy from wifi to hardwired? Can you buy a better wifi card or something to make the wifi match or be as close as possible to the ethernet connection?

 

Constantly disconnecting with ethernet cable

Hello,

Thank you for keeping us posted on the status of the issue.

I suggest you to check if rolling back the Ethernet driver helps to resolve the issue. Follow the below steps.

• First of all, Press Windows logo + R from keyboard. It will open
  RUN.
• Now type devmgmt.msc and press Enter to open Device Manager.
• You will see all the device list of your PC. Expand Network Adapters

Rollback driver

Double click on your Ethernet driver in Device Manager. Then Click on
Driver tab and select Rollback.

Important: If your drive is performing well and there is no error, Rollback driver button will be grayed out as an option.

If it still does not help, I suggest you to reinstall the drivers for the Ethernet driver and check if it helps to resolve the issue.

Note: Once you uninstall the drivers the Ethernet adapter device will be disabled and you won’t be able to connect to internet. So it is advisable to keep all the installer files as a back up in your hard drive.

Write to us with the results for further assistance.

Thank You.

 

Sleep Mode Disconnects Ethernet Internet Connection - An Oldie but a Goodie

Hi,

There's a possibility that your Ethernet connection is not enabled to wake on magic packet. For us to isolate this, let's look into the advanced settings of your network adapter. Follow these steps:

1. Navigate to Device Manager > Network adapters.
2. Right-click on your Ethernet connection and click Properties.
3. Click the Advanced tab.
4. Under Property, scroll down and select Wake on magic packet.
5. Set the value to Enabled.
6. Click OK.

Once done, try to observe if Ethernet connection still disconnects if put to sleep mode.

Looking forward to your reply..

Regards.