Windows 10: Event log error please help

Please any advice would be helpful believe a may have faulty mobo as having problems when dim1 is occupied

:)

 

Error in Event Viewer

Hi,



Thank you for writing to Microsoft Community Forums.



As you have mentioned, you have performed a repair installation on the computer and you see Event 508, 510 and 533 in Event Viewer.



I would like to inform that if you see any critical error in Event Viewer, please share the event logs with us to help you with the appropriate troubleshooting steps. Please follow the steps mentioned below to share the event logs:

1. Press Windows + X from the keyboard, select
   Event Viewer.
   
2. Expand Windows Logs from the left pane and select
   Applications.
   
3. Click Filter Current Log from extreme right pane. Then in the new windows check the box beside
   Error and click OK.
   
4. Now, look for a critical Error in the list and note down the message/information from the
   General Tab in the lower section.
   

Please reply with the status of the issue, we will be glad to help you further.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Event Error Log

Windows 10 Event Error Log - Summary Section

One of the Logs listed needs to be deleted since this application has been removed from my laptop. Is there anyway to remove it from the Log -Summary Section?

 

Event "Error" Log Repair required (Windows 10)

Hi,





There are a lot of
possibilities why these errors occur in
your event logs. The errors depends on what it is related to. It could be your
application, drivers, firmware, hardware, or your storage devices. You can check this
link for further information regarding event log issues.



We suggest that you perform these following methods of troubleshooting steps and check if there's any changes:



Method 1: Update your drivers.

To know how to update your drivers, click
here.



Method 2:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 3:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    
  
  
  

NOTE:
This might take a while to finish scanning.
Do not cancel. 



Method 4: Clean Boot.

To perform a
Clean Boot, click
here.



Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.



Let us know how it goes.



Regards.