Windows 10: every thing is good.

its all ok

:)

 

Phenom 9850BE low voltage overclocking results!

well if your going to continue with overclocking, i suggest doing the baby steps thing heh. good luck with the overclocking

 

What kind of quad.

I suspect you are at "the edge" of the power rating for the mainboard. Perhaps Q6600 wasnt listed due to TWO versions, C3 stepping at 105W and G0 stepping at 95W. Furthermore, if you OC the G0 Q6600 then it will use more than 95W. Since Q9300 is on a 1333 buss, then perhaps the BIOS doesnt give you scope to OC it, keeping it well withing the 95W envelope.

My suggestion is, if the mainboard is important to you and you dont want to blow the power regulators or caps, to NOT OC the Q6600. Take the thing out of design spec (by OC'ing it) and you may very well rapidly reduce the half-life of your board.

Also, as erocker suggests, there are 65W quads out now. I think those are better suited to this mainboard.

Good luck.

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.