Windows 10: Factory OS errors when using BuildWSKImage

I'm trying to create a Factory OS image, for a VM, using this guide: https://learn.microsoft.com/en-us/windows-hardware/manufacture/desktop/factoryos/?view=windows-11I've got as far as the step which asks you to run BuildWSKImage, but get several errors, including:imageapp INFO ThreadId11384 [00:01:49] Entered IUSubphase WimCommit imageapp INFO ThreadId27384 [00:01:51] Staging progress: 55% imageapp INFO ThreadId27384 [00:01:53] Staging progress: 56% imageapp : ERROR : ThreadId11384 [00:01:54] WIL Origination: onecore\base\cbs\mobile\iucommon\iuutils.cpp1935\UpdateDLL.dll

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

bottleneck or OS error?

It can't be the os. And yes i'm suggesting either bottleneck or drivers.

 

Cannot recover Windows 8 OS, error that I have not created an account

Hi,

As per the added information, I suggest that you run the command below to deactivate the administrator account and check if you will be able to roll back to the old OS that was installed prior to Windows 10.

Steps to: Disable Built-in administrator.

• • Press Windows + X key together on your desktop screen.
  • Click on Command Prompt (admin) to open Command Prompt.
    
  • Type the following command and hit Enter:
  • net user administrator /active: no

To roll back to the previous OS, you can follow the steps mentioned in the previous post and after selecting
Reset This PC select Factory Settings. This will revert your PC back to the original OS that was installed when the PC was purchased.

Note: Create the Media Creation Tool to perform the above action.

Hope this helps