Windows 10: Factory resetting gone wrong.

I need to reset my dell laptop i did and it was going good until it told me to sign in but i cant because it reset it because it stops at 48 and it says undoing changes i dont know what to do please help me.reset it again but it must does the same thing i need help

:)

 

Diskpart : there are no fixed disks to show.. Factory reset gone awful

Hi everyone, I was asked to factory reset an Asus laptop and install a win 7 on it, while starting to install the win 7 I got stuck with the "no device drivers were found", searched for some tutorial on YouTube, found this vid: , followed the command codes step by step on MS-DOS : ( Diskpart >>> list disk >>> select disk 0 >>>> Clean >>>> create partition primary >>>> format fs=ntfs quick) and now I completely lost the disk 0 with all system files, no hard drive showing as a boot option in the BIOS. Am I screwed ? Is there a way to create or reactivate the internal HDD ?? Thank you in advance for your help

 

Factory Reset Gone Wrong

I tried to factory reset my computer yesterday.

I got stuck on the "Why my PC reset screen". Every time I would click continue and try to connect to my house wifi (which is working fine on every other device), it would load for a while before returning back to the "LEt's get started screen" which prompted
the "Why my PC reset screen".

I tried troubleshooting with various tips and message boards.

I tried booting into safe mode by turning it on and off 3 times, but when I turned it on the 3rd time, my monitor would say "no signal" and the screen would go black even though my computer was turned on and running.

I downloaded the Windows installer thing that people recommended and went through the steps, but I was either stuck on the PC reset screen or had no signal on my monitor so I was unable to ever use the USB with the files on it.

This is my first Windows computer so I am not familiar with any of the keycodes or little tricks.

Please Help.

 

Factory reset gone wrong !

Hi, Zoe

My name is Maritza and I am an Independent Advisor. I would be happy to help you today.

Try to enter Safe Mode with network function to repair Windows.

Interrupt the normal boot process of your Windows 10 PC

If Windows 10 fails to boot normally three times over, the fourth time it enters by default in an Automatic Repair mode. Using this mode, you can boot into Safe Mode. To trigger the Automatic Repair mode, you must interrupt the normal boot process three consecutive
times: use the reset or the power button on your Windows 10 PC to stop it during boot, before it finishes loading Windows 10. If you use the power button, you might have to keep it pressed for at least 4 seconds to force the power off

Then you proceed to repair the computer:

With a reset, all of your Installed applications are lost, but you get an option to save your files if you want. If a system image from the OEM exists-called a recovery partition, then it also gives you an option to restore it. It would make your PC load to
default factory settings.

Navigate to Troubleshooting section, again.

Select Reset.

If you select keep my files, your files would be kept. You might also get the third option-restore to factory settings-which isn’t applicable on the PC.

After selecting the desired options, you are presented with a confirmation, something like this- This indicates what you have chosen.

Click on Reset and the resetting should begin.

Let us know if these steps help you to resolve the issue.