Windows 10: Fail to boot

My Asus Vivobook is on window 11. All of a sudden, it froze. I used the power key to do a forced shut down. After it was turned back on, the screen showed “preparing automatic repair” then showed a blue screen of “BitLocker”and asked me to “Enter the recovery key to get going again Keyboard Layout US”, I found the recovery key from another device, but after inputting the key, it still did not work, circling back the same screen which asked me to input the recovery key. I tried to click on “Skip this Drive”, then the screen showed “Automatic Repair, Your PC did not start correctly….”, I chose

:)

 

HD 5870 Bios flash failed

mp3 player is in FAT / FAT32 format ?

Set Boot up first to the drive with hiren bootcd 10.4
Done...

the options will pop out after loading the disc choose

boot cd

then the list (step by step)

Next...
Dos....
USB Drivers....
Load USB Drivers with no386.....

Ask you load cd drivers. NO
Ask you load SCSI drivers. NO
Ask you anything NO.
USB driver list comes out. 8 Don't choose anything else.

type
C:\ (that should be your mp3 player if you did it right)

atiflash -i
to list the adapters

atiflash -p -f 0 ???.bin

done.........

 

Boot Process

Hi,

Please suggest me a link that can explain the boot process step by step of ...

• Windows 7,
• Windows 8.1,
• Windows 10,
• Windows Server 2008 R2 and
• Windows Server 2012 R2

With Regards

InTech

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".