Windows 10: FAT32 not opening.

I've just tried my new Film Scanner. It downloads to an SD card. Windows 10 says the card is empty yet properties report 138kB used on the card in a FAT32 file. Anybody got a clue as to how to open this FAT32?

:)

 

FAT32 formatting

If you can plug the drive into a XP system you can partition and format to FAT32 through Drive Configuration. Heres the steps

1. Click Start and go to your control panel

2. Go into Administrative Tools and then open up Computer Management

3. Now click on Disk Management that is located under Storage.

On the right you should see your drive that you want to format to FAT32. Just right click the drive, select format, and switch partition to Fat32. You may need to delete the volume if it will not let you change to Fat32 and then repartition. I have used this many times.

 

Unable to open files on FAT32 Drives (Do not have permission)

Hi Chad,

Thank you for posting in Microsoft community.

Sorry for the inconvenience caused to you. I’ll certainly help you with this.

I would like to let you know that Windows 10 doesn't support FAT32 formatted drives. I suggest you to take the back up of the files and format the drive in NTFS format. To do so, follow these steps:

• 
  Connect the USB drive to the computer and right click on it.
  
• 
  Select format and set the file system to
  NTFS(default).
  
• 
  Select click on Start to format the USB drive.
  
• 
  Now, transfer the files to the drive and check if you are able to open the files.
  

Hope this will help you. Keep us posted with the status of the issue to assist you further.

Thank you.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!