Windows 10: Fix driver problem after windows uodate

Yesterday i updated my laptop (update and shutdown) and today when i turned it on, the drivers were messed up. I noticed the audio driver problem. Troubleshooting did nothing. I uninstalled the driver amd still. I reverted to the last system restore point and still. What should i do? I just notices the camera is not working either Relevant info: Toshiba satellite s855-s5369 Windows 10 pro Vesion 1909 Os build 18363.778 64 bit core i5 12gb ram More than enough storage

submitted by /u/kattiper
[link] [comments]

:)

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

DTS supported natively by Windows 8/8.1 and it should work on windows 10 too just DDL require to unlock your driver .

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

Wait, but have you done the whole step-by-step guide described in the OP? DDL/DTS isn't supported natively by Windows 8/8.1 either, unless if you do the steps listed there.

 

Most recent Windows 10 uodate problems...

Hello,

Thank you for posting your query in Microsoft Community.

We sincerely apologies for delay in responding and regret the inconvenience caused to you.

Let's try the following steps and check if it helps:

Method 1: Run Windows Update Troubleshooter

I suggest you to run the Windows Update Troubleshooter. Follow these steps to run Windows Update troubleshooter:

• Type troubleshooting in the search bar and select it.
• Select View all on the top left corner.
• Click Windows Update troubleshooter.
• Follow the on-screen instructions to run the troubleshooter.
• Check if issue persists.

Method 2:

I suggest you to check if the services responsible for Windows update is running. Refer to these steps:

• Press Windows key +R, type “services.msc”
• Locate the BITS, Cryptographic, MSI Installer and the
  Windows Update Services and check if it is running.
• If not, right click on the service and click start to start the service.

Method 3: Place the computer in Clean Boot and then install the updates

To help troubleshoot error messages and other issues, you can start Windows by using a minimal set of drivers and startup programs. This kind of startup is known as a "clean boot." A clean boot helps eliminate software conflicts.


Refer the article below to perform clean boot:

http://support.microsoft.com/kb/929135

Note: Please refer to the section:
How to reset the computer to start as usual after troubleshooting with clean boot
of the Kb article to boot the computer in normal startup after fixing the issue. Steps applies to Windows 10 as well.

Disclaimer: A clean boot is performed to start Windows by using a minimal set of drivers and startup programs. This helps eliminate software conflicts that occur when you install
a program or an update or when you run a program in Windows. You may also troubleshoot or determine what conflict is causing the problem by performing a clean boot. You must log on to the computer as an administrator to be able to perform a clean boot. Your
computer may temporarily lose some functionality when you perform a clean boot. When you start the computer normally, the functionality returns. However, you may receive the original error message, or experience the original behavior if the problem still exists.
If the computer is connected to a network, network policy settings may prevent you from following these steps.

Hope this will fix the issue, if not let us know with the updated status and we will be happy to assist you further.

Thank you.