Windows 10: Fixed error and now still get BSODs. Why?

My computer used to get BSODs every now and then, specially while playing games. I managed to figure out it was caused because of a service incompatibility with my ram, that is older than my computer. I just deactivated that service and then everything was good! The report of the perfmon /report didn't show any other e

:)

 

BSOD issue after fixing another BSOD error

Hi Williams,

There are several reasons why BSOD occur, which has different resolution. To check for any corruption or the integrity of your computer's Windows, we suggest that you perform a
Check Disk by following these steps:

• Type cmd in the search bar.
• Right-click on the Command Prompt, then Run as administrator.
  
• Type chkdsk x: /r, the /r command will fix errors found on the disk.

Let us know if you need further assistance.

 

BSOD - Registry Error

Your BSOD code is 0X000000051

Here's the Google search I did for it: https://www.google.com/search?q=0x0...j5.399j0j7&sourceid=chrome&es_sm=122&ie=UTF-8

There is a hotfix available that might help, https://support.microsoft.com/en-us/kb/810558

This thread makes a few good suggestions too: http://www.sevenforums.com/bsod-hel...dows-7-pro-sp1-registry-error-0x00000051.html

+1 to listing your full system specs, OS version, etc. I did only look at your BSOD log file.

Run a Diskchk /R (I know you already ran one, so you can skip this)

Run SFC /SCANNOW

Report back.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.