Windows 10: Flas drive from Vista

My flash drive that I used when I had a computer with Vista will not work on my new computer with Windows 10. It says that it has to be formatted and a second pop up says unreadable file format. How do I fix this.

:)

 

How to Partiton a Hard Drive in Vista

This is a way to get Vista to see another hard drive that is not associated with the OS. There is some times when your new hdd doesn't seem to want to work well with Vista. But, there is a solution in it.

Open the Computer Management By doing these steps.

• Click on the Start Button
• Click on Control Panel
• Click Administrative Tools
• Double click on Computer Management

You are now in the Navigation panel of the Computer Management.
When in Computer Management, you then have to allow the new drive to be recognized.

• Double click on Storage
• Double click on Disk Management

Now in the middle of your screen there is the layout of the Disk Drives that you have. The drives that are partitioned will show by the drive lettering. The others will just show up as having nothing at all in them. Below that there will be the Disk drives that are installed into the computer. You'll see that the primary one will all ways read as "Disk 0". Then you will have Disk 1 and so on. Under the Disks there will also see your CD-Rom drives.. If there is more then one, it will be labeled the same as Disk drives..

On to the Partitioning of the drive in question.

• Right Click on the drive
• Click to format the drive or Enable Volume. There will be a series of windows that open up. This is Vista's formatting. Just go threw the windows, and make sure everything is the way you want it to happen.
• Once the formatting is done, will take some time depending on the drive size.
• Right click on the drive
• Click on Mark the Partition as Active

After you have done those steps, The drive will be up and running threw Vista.



:Side Notes:
If you are not the Administer to the Os, then you will have to enable it..
You may also want to redo the drive lettering of it all. But, I really don't see a reason to do so. If you do, you have to redo drive paths and so forth.. A lot of work on something so small...

 

Disk boot failure after removing old Vista partition

Thank you for the reply, muchomurka! As I indicated in my post, I have already tried all the steps you suggested to no avail:

- I cannot choose startup repair since the computer does not boot from the installation media
- I cannot use command prompt since the computer does not boot further than the POST screen
- I have disconnected and tried out all hard drives individually.

Since I had Win 10 up and running a few hours ago, I can say with 100% certainty that none of the hardware is faulty.

The real mystery is, how come the system won't boot from any media without an empty disk containing an old Vista boot sector being on top of the boot priority list? And which steps to take now that I've cleaned this disk and it does not exist anymore?

Would appreciate any ideas and pointers!

 

Vista Beta 2 Installed

Well first I defragged the drive, then go into partition magic and select "create a new partition" and make sure it is "after c:"

Then click the rest of the way through the menus, and in the lower left there is a list of pending activites and click "apply" and you will have to restart and before windows boots partition magic does its thing.