Windows 10: flash bellek format

flash bellek format atarken cmd kod dizinde hata oldu ardından flash bellek hiçbir şekilde gözükmüyor list disktede gözükmüyor en son ntfs ye dönüştürmüştüm formatım yarıda kaldı :

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

install.wim is 7GB, how to make a bootable USB flash drive

This is a method to make a ntfs flash drive.

The trial and error step will be booting using Legacy BIOS...

Code:

This is the link:
Guide: How to Format USB Flash Drive Using Cmd - EaseUS

The link did not use active so that is why it is a trial and error step.

 

USB Flash Drive saying not formatted..?

Hi,

I have a Memorex Poker Chip USB Flash Drive 1GB, and It shows up fine on one PC as "Poker Chip" in explore, and I can transfer files... but on my other PC (the one I'm on now..specs in profile) it's listed only as H: Removable Disk, and when I click on it, it says: "The Device is not formatted, would you like to format it now? (Y/N). Why would it be recognized on one PC, but the not the other? How come the other PC didn't need it formatted? When I click yes to format it, it says: "Windows was unable to complete the format"

I went to the BIOS and USB 2.0 is enabled. And Device Manager does list it as a Memorex Poker Chip..