Windows 10: Flash Of cmd.exe

I can't reproduce it. Every now and then I see two launches of cmd.exe. They appear to be when I restart the machine and login, but they don't occur every time.I checked Task Manager's startup list and don't see anything that uses cmd.I looked through Tasl Scheduler as much as I could but couldn't find a cmd launch.Is there any way to setup some sort of logging for cmd.exe?

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

install.wim is 7GB, how to make a bootable USB flash drive

This is a method to make a ntfs flash drive.

The trial and error step will be booting using Legacy BIOS...

Code:

This is the link:
Guide: How to Format USB Flash Drive Using Cmd - EaseUS

The link did not use active so that is why it is a trial and error step.

 

Cmd related

Some scheduled tasks may have run that caused the Command Prompt windows to pop up. To know the tasks that recently ran on the computer, try the PowerShell method listed on this page → Command Prompt Flashes and Closes Quickly at Startup or Random Intervals

To check your system for malware, follow these steps:

Download Farbar Recovery Scan Tool (FRST64.exe) from the following link:

Download Farbar Recovery Scan Tool



(FRST64.exe doesn't remove anything automatically when you click "Scan". Instead, it scans all the launch points, services, and drivers and lists them.)

• Run FRST64.exe and click "Scan".
  
• Upload the two logs, namely, FRST.txt and Addition.txt, to your OneDrive and share the link here.