Windows 10: Flashing disks on Windows screen & little control of mouse

Hi all. I have an intermittent problems. Every few weeks, flashing disks of light appear, mainly on the taskbar (as shown).

At the same time I almost lose control of the mouse. Rebooting fixes it for about 30 minutes and I have to reboot again.

Eventually it stops, but then recurs in another for weeks.

I've tried searching online, but haven't found the same problem.

Regards, Jim

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Floppy disk controller which will not function in Windows 10

Hi Bob,

This issue may occur due to compatibility issues. Normally, if the new drive was reformatted, it gets a drive letter automatically and you do not need to take any further actions. Regarding the floppy-disk controller concern, please answer the following:

• How did you install the floppy-disk controller on your device?
• Have you tried downloading the latest driver for the floppy-disk controller on its manufacturer's website?
  

In the meantime, we suggest that you run the built-in hardware and devices troubleshooter in Windows 10. To do this, refer to these steps:

• Press Windows key +X and select Control Panel.
• Change the View by option on the top right to Large icons.
• Choose Troubleshooting and click on the View all option on the left panel.
• Run the Hardware and devices troubleshooter.
• Follow the on-screen instructions.
  
• Restart your computer.

Please post back with the status of the issue, we'll be glad to assist you further.

 

Taskbar bug: switching to another window -will not appear at the front


Follow either of these steps to fix the issue with the Active window hiding behind.

Method 1:
I suggest you to disable window by hovering over it with the mouse and check if it helps. To do so I suggest you to try the below given steps and check if it helps:

• Press Windows key + X key and click on Control Panel.
• Select or click Ease of Access.
• Click or tap onEase of Access Centre.
• Click on Make the Mouse Easier to Use was uncheck Activate Window by hovering over it with the mouse.
• Check if issue is resolved.

Method 2:
I would suggest you to completely uninstall the touchpad driver and reinstall it. Kindly follow the below given steps.

• Press “Windows key + X” and click on “Device Manager”.
• In the list of devices, you should see the touchpad drivers.
• Right click on the device and then select "Uninstall".
• In the uninstall dialog, make sure you select the option to delete the driver package from the system. This causes the driver package installed earlier to be deleted.
• In the Action menu of Device manager, select “Scan for Hardware changes” option. This will cause the device driver to be reinstalled. Once the driver is installed, close all windows and restart the computer.