Windows 10: Format disk before you can use it

So I was creating bootable windows 10 on my pen drive using the windows media tool from the official Microsoft website. it was going well but at one point it stopped at 50% it was not moving at all for like an hour. tried to open another program but it got froze "not responding" For 30 more minutes it's still stuck in not responding. I had to restart the laptop now my pen drive as I insert it again says "you need to format the disk g: before you can use it. unable to format it as i try to format it also CMD method is not working it says chkdsk is not available on raw drives

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Cannot Format HD


Need to initialize it as GPT disk type with HD > 2TB:
From Admin command prompt:

1. diskpart
2. list disk =====> Take a note of disk # for the 4TB HD
3. select disk # ====> From step 2
4. clean
5. exit

Open Disk Management and initialize the disk as GPT, create simple then format.

 

Windows format disk message

Hello Marcos,

There may be several reasons why you are being prompted to have your pen drive formatted every time you plug it in to your PC. This prompt, however, may not be disabled. To isolate what's causing this issue, kindly answer the following questions:

• When did this issue start?
• Were there any hardware/software changes on your PC prior to this happening?
• Was your pen drive improperly pulled out from the USB port?
• Have you tried plugging your pen drive to a different USB port or a different computer?

In the meantime we suggest you to check if your pen drive appears under
Disk Management without any error. To check, follow the steps below:

• Click Windows + X.
• Select Disk Management.
• Check and see if your pen drive shows on the list.

We will be waiting for your response.