Windows 10: Format Error in D drive

Hi AllI m getting below error while trying to access D drive of my laptop. This is not an external drive.I have tried below in CMD-I have some data in D drive so don’t want to format it.Pls advice.RegardsPankaj

:)

 

D drive

Hi,

Based on the details you have provided us, it appears that there might be some corrupted contents on the said partition. We can also consider that this is caused by a virus.

For us to check if a certain virus is hiding your files, kindly follow the steps below:

• Type Command prompt in the search bar.
• Type-in the following command:
  
  attrib -h -r -s /s /d D:\*.*
• Press Enter to execute the command.

If you think that there is nothing important stored in it, then we suggest that you reformat your D drive so that you can use the free space for important files.

You can follow the steps below to start with the process:

• Click on the File Explorer.
• Select This PC.
• Right-click on your D drive, then click on Format.
• Follow the on-screen process to finish formatting the partition.

Let us know how it goes so that we can further assist you.

 

Cannot access D drive since upgrading to Windows 10.

Hello Judy,



Thank you for replying quickly with the status of the issue.



Please reply to few more questions:

• 
  Is the D: drive located on the same hard disk or on different hard disk?
  
• 
  Did you have any important data saved on the
  D: drive?
  

If the D: is saved on another hard disk and you are unable to access it, I suggest you to format the drive completely and check if the issue is resolved.



To format the hard disk, follow the steps below:

• 
  Press Windows logo + X keys on the keyboard and select
  Disk management option.
  
• 
  Right click on the D: drive and select
  Format option.
  
• 
  Wait for the formatting to complete and check if the changes are effective.
  

Write to us with the status of the issue for further assistance. Your reply is most important for us to ensure we assist you accordingly.



Thank you.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!