Windows 10: Fresh Install Results in BSOD

So I did a fresh install of Windows 11, only to be met with a BSOD loop with multiple errors:-System service exception-ntoskrnl.exe-irql not less or equal-Reference by pointer-Kernel mode heapI am installing Windows via a usb drive. I have tried 4 different version of windows, Tiny11, Ghost spec., ISO from Micrsoft and a stripped down version I made myself. All result in the same issue. I made the boot disks with rufus and ventoy. I have unplugged all usb devicesexcept mouse/keyboard. I swapped out the video card. I removed extra ram. Disconnected the HDD. Tried putting the usb boot disk in

:)

 

Multiple BSODs in a fresh install of Windows 10


Daemon tools, Alcohol 120% and Power Archiver Pro uses SCSI Pass Through Direct (SPTD), which is a well known cause for BSOD's.
Please remove Daemon Tools and run the SPTD pass through remover.

1. Uninstall Daemon Tools
2. Download the SPTD standalone installer and follow these steps:
   • Double click the executable to open it
   • Click on the button shown below

If the button is grayed out, like in the image, there is no more SPTD installation on your system, and you can close the window

 

CLOCK_WATCHDOG_TIMEOUT after a fresh install

 

BSOD on install from USB

Have an HP Notebook 14-cf0013dx, 8gb ram, 1TB HDD 5200rpm (full specs are in profile)

Attempting to reinstall windows after BSOD on start, mostly page fault in non paged area BSOD error but can also be irql not less or equal, or Kernel Secure check failure. Saw another one or two but cannot recall at the moment.

Symptoms. Can boot to USB in UEFI or legacy and Load the windows 10 install made from the windows creation tool. The loading files completes. The system restarts and the HP splash screen appears with the windows 10 dots circling underneath for about 2 revolutions then a BSOD.

First steps:
Tried windows 10 recovery. over 48 hours still not completed.
Ran HP hardware diagnostics, Memory HDD, system board all passed.
Ran memtest86 from Hirens Boot CD. passed.
Ran seagate HDD test. passed.
Tried windows 10 USB install after each step above.
Tried Windows 10 safe mode installation, was able to get through installation but on reboot the same results, BSOD within 3 revolutions of startup dot-circle.

Second steps:
Removed HDD, hooked up to main computer and did a CMD, DISKPART, CLEAN
Updated BIOS to most recent version F.53 to support windows 10 v.1909
Moved DIMM from slot 1 to slot 2
Tried HP cloud recovery with exact same results as listed above.
Tried Windows 10 USB safemode install again same results. Was able to complete installation from USB but BSOD on restart.

Short of replacing the Motherboard due to the integrated graphics memory (which still tested good in HP system board test), I am at a loss. Please help with any suggestions.