Windows 10: FXE over IPv4, FXE over IPv6 upon booting

Hello! I have recently bought a new SSD. Then, I set the SSD as an external hard drive and copied everything from my old C: drive to the new SSD. I then removed the old drive and set the SSD as the new C:. Now, when booting, this message appears:>>Checking Media Presence......>>Media Present......>>Start PXE ov

:)

 

Connectivity (IPv4/IPv6): Disconnected

Hi,



Thank you for writing to Microsoft Community Forums.



Ideally this Connectivity (IPv4/IPv6): Disconnected, means that the devices in not in use or not connected and it could be any device for example, Ethernet, WIFI, Bluetooth or Local Area Connection.



If you are using WI-FI for internet connection then Ethernet will show Connectivity (IPv4/IPv6): Disconnected.



In order to understand the issue and assist you accordingly, we need some information

• What is your network setup?
  
• Are you seeing any errors?
  
• Where you are seeing this information?

Meanwhile, try the troubleshooting steps referred in this article:

Fix network connection issues in Windows and check if it works.



Regards,

Aditya Roy

Microsoft Community – Moderator

 

Prefer ipv4 over ipv6

hi, I want to set ipv4 to be preferred over ipv6, the other day i've used the tips from this Ping returns IPv6 Address, ping IPv4 in Command Prompt - TheITBros on my 2 windows10 computers and everything worked out great! Now, i just did a win10 update and i noticed that that no longer works even by doing the very same "command" and it kinda gets ignored. Did they just remove the functionality? This is what i get from netsh interface ipv6 show prefixpolicies (i don't get the longer list anymore but just these):

So it seems to be preferring ipv4, yet when i ping my site (available on both ipv4 and ipv6), i get output with ipv6, same as google.com - the other day it was working nicely to ipv4 and i only used these 2 commands they suggested: netsh interface ipv6 set prefix ::/96 60 3 netsh interface ipv6 set prefix ::ffff:0:0/96 55 4 what's going on? I don't want to disable it completely (i know i can disable it from the router or from the network card properties, i just want to de-prioritise it) [Version 10.0.19044.1387] thank you, Gabrio - - - Updated - - - might have answered myself, i've added netsh interface ipv6 add prefixpolicy ::/0 40 1 and it did the trick... i wonder if it will stick now

 

Network switching from IPv4 to IPv6

You can follow the steps given in this help to force to IPv4

http://www.thewindowsclub.com/enable-disable-ip...